The ECM uses dual oxygen sensors to monitor the efficiency of the manifold catalytic converter (warm-up catalytic converter). By monitoring the oxygen storage capacity of a catalyst, its efficiency can be indirectly calculated. The upstream (front) HO2S is used to detect the amount of oxygen in the exhaust gas before it enters the catalytic converter. A low voltage indicates high oxygen contents (lean air mixture). A high voltage indicates low oxygen contents (rich air mixture). When the catalyst efficiency drops, no chemical reaction takes place. This means the concentration of oxygen will be the same at the rear as it is at the front. The output voltage of the rear HO2S copies the voltage of the front HO2S.To monitor the system, the lean-to-rich switches of the front HO2S to the rear HO2S is counted. The ratio of rear switches to front switches is used to determine whether the catalyst is operating properly. An effective catalyst will have fewer rear switches than front switches, that is, a ratio closer to zero.
The ECM calculates oscillation size of rear HO2S signal which respresents catalyst conversion properties. This oscillation size will determine if catalyst conversion is low due to aging or poisoning from leaded fuel or misfiring. The ECM sets P0420 if the average of caculated oscillation size of rear HO2S signal during predetermined duration is higher than the predetermined threshold.
Item
Detecting Condition
Possible Cause
DTC Strategy
? Comparison of the signal ratio of upstream and downstream O2 sensor in a load and speed range
? Exhaust gas leaks
? Rear HO2S malfunction
? Three way catalyst converter malfunction
Enable Conditions
? Catalyst model temperature:400 ~600?(752~1112?)
? Coolant temperature >70?(158?)
? Lambda control within limit
? Engine speed:800 ~2500rpm
? Air mass flow <250 mg/stk
? No misfire is detected
? Not transient condition
Threshold Value
? Averaged malfunction index > 0.7
Diagnostic Time
? 150 lambda controller cycles