The Wheel Speed Sensor (WSS) generates a waveform with a frequency proportional to the speed of the vehicle. The signal generated by the WSS informs the ECM not only if the vehicle speed is low or high but also if the vehicle is or is not moving. The ECM uses this signal to control the fuel injection, ignition timing, transaxle shift scheduling and torque converter clutch scheduling. The WSS signal is also used to detect rough road conditions.
The ECM evaluates engine speed and mass air flow if there is no vehicle speed signal. This evaluation of both values will detect open circuit or short circuit errors on the wheel speed sensor. The ECM sets DTC P0501 if there is no vehicle speed signal from wheel speed sensor while both engine speed and mass air flow are higher than predetermined threshold during the predetermined time.
Item
Detecting Condition
Possible Cause
DTC Strategy
? Check vehicle speed signal
? Open or short in harness
? Contact resistance in connectors
? Defective wheel speed sensor
Enable Conditions
? Engine speed >2016 rpm
? Mass air flow >218mg/stk
? Coolant temperature > 60?(140?)
? No fuel shut-off
Threshold Value
? Vehicle speed=0 with high engine speed and high load
Diagnostic Time
? 60 sec.(AT)/40 sec.(MT)