Component Location
General Description
The rear heated oxygen sensor is mounted on the rear side of the Catalytic Converter (warm-up catalytic converter) or in the rear exhaust pipe, which is able to detect catalyst efficiency. The rear heated oxygen sensor (HO2S) produces a voltage between 0V and 1V. This rear heated oxygen sensor is used to estimate the oxygen storage capability. If a catalyst has good conversion properties, the oxygen fluctuations are smoothed by the oxygen storage capacity of the catalyst. If the conversion provided by the catalyst is low due to aging, poisoning or misfiring, then the oxygen fluctuations are similar to signals from the front oxygen sensor.
DTC Description
Checking output signals from HO2S under detecting condition, if an output signal is above 1.3V for more than predeterminate time, ECM sets P0158. MIL(Malfunction Indication Lamp) turns on when the malfunction lasts till consecutive 2 driving cycle.
DTC Detecting Condition
Item | Detecting Condition | Possible Cause |
DTC Strategy | Monitor signal voltage
| Poor connection
Short to battery in harness
HO2S(B2/S2)
ECM
|
Enable Conditions | Battery voltage = 10V
Engine running = 60 sec
Engine warm-up state
|
Threshold value | The voltage of HO2S(B2/S2) > 1.3V
|
Diagnosis Time | Continous (more than 12.5 sec.failure for every 15 sec.test)
|
MIL On Condition | 2 Driving Cycles
|
Specification
(Reference only)Test Condition | HO2S Voltage(Sensor1) | HO2S Voltage(Sensor2) |
HO2S Signal at idle after warm-up | Signal is commonly switching from rich to lean more than 3 times in 10 sec. | Signal is commonly above 0.6V. |
HO2S signal at open circuit (Pumping current OFF) | Approx. 0.45V |
HO2S signal at open circuit (Pumping current ON) | Approx.2.2V |
Diagnostic Circuit Diagram
Signal Waveform & Data
Fig.1) Normal waveforms of front HO2S(the upper) and rear HO2S(the lower). (Waveform between HIGH signal line of HO2S and chassis ground)
Fig.2) Normal graph of front HO2S and rear HO2S at idle.
After warming-up, if accelerator pedal is released suddenly around 4000rpm, the HO2S signal reading will be lower than 200mV resulting from Fuel cut-off for the moment. Conversely, if suddenly accelerator pedal is depressed, HO2S signal reading will be around 0.6V ~1.0V. At idle, Normally HO2S signal will switch from lean to rich with 3 Hz. And as racing, Its frequency rises.