Component Location
General Description
The Electronic Throttle Control(ETC) system is made of the components throttle body, Throttle Position Sensor(TPS)1&2 and Accelerator Position Sensor(APS) 1&2. The throttle body contains the actuator, the throttle plate and the throttle position sensor (potentiometer), which are integrated in one housing. The actuator consists of a DC motor with a two-stage gear. The opening angle of the throttle valve is detected by the throttle position sensor which is mounted on the throttle body. And it provides feedback to the ECM to control the throttle motor in order to control the throttle valve opening angle properly in response to the driving condition.
DTC Description
In case an error happenes during ETC motor spring adaptation or TPS spring is out of order, ECM sets P2119.
DTC Detecting Condition
Item | Detecting Condition | Possible Cause |
DTC Strategy | ETC Monitoring
| Poor connection
Incompleted of unexecuted adaptation
Faulty motor
|
Enable Conditions | IG On
|
Threshold Value | Error or abort during the ETC motor spring adaptation
Limp-home pos. 1.8~13.1%
ETC without adaptation procedure after replacement
ETC amplification factor error
Abort during the initial adaptation
Abort during the re-adaptation
|
Diagnostic Time | Once at IG ON
|
MIL ON Condition | 1 driving cycle
|
Signal Waveform & Data
This is a ETC motor signal waveform with acceleration.
ECM controls ETC motor(DC motor) to operate the throttle valve.
ETC motor operate and change the throttle valve position in order to open the closed throttle valve under the acceleration condition.