General Description
In order to provide the best possible combination of drivability, fuel economy and emission control, the PCM uses a closed loop air/fuel metering system. The PCM monitors the HO2S signal voltage and adjusts fuel delivery based it in closed loop fuel control. Changes in fuel delivery will be indicated by the long-term and the short-term fuel trim values. The ideal fuel trim value is around 0%. The PCM will add fuel when the HO2S signal is indicating a lean condition. Additional fuel is indicated by fuel trim values that are above 0%. The PCM will reduce fuel when the HO2S signal is indicating a rich condition. Reduction in fuel is indicated by fuel trim values that are below 0%. The DTC relevant to fuel trim will be set when the amount reaches excessive levels because of a lean or rich condition.
General Description
If the fuel trim values reaches the maximum or minimum threshold, then feedback control is no longer possible and emissions will be increased. The PCM sets DTC P0170 if no proportional fuel adaptation occurs for a defined time after the short term fuel trim has reached its minimum or maximum threshold.
DTC Detecting Condition
Item | Detecting Condition | Possible Cause |
DTC Strategy | Monitoring deviation of short term fuel trim control
| Air leakage or restriction in intake or exhaust system
Dirty engine oil or oil level too high
Front HO2S or MAFS contamination
Fuel system
EVAP system
Faulty sensor signals
|
Enable Conditions | No relevant failure
Lambda control active
Coolant temperature>73?(163?)
|
Threshold Value | +50 % < Short Term Trim < -30 %
|
Diagnostic Time | 90 sec.
|
Mil On Condition | 2 Driving Cycles
|
Signal Waveform & Data
1. GDS Display for HO2STest Condition | GDS Parameter |
O2 SNSR VOL.-B1/S1 | SNSRO2 SNSR VOL.-B1/S2 |
Normal Value when circuit is normal | Idle after warm up | Signal is switching from rich(above 0.45V) to lean(below 0.45V) a minimum of 3 times in 10 seconds. | above 0.7V |
HO2S(B1S1) signal circuit open | Approx. 0.43~0.45V | - |
HO2S(B1S2) signal circuit open | - | Approx. 0.43~0.45V |
2. MAPS Terminal voltage with pressurePressure (kPa) | Approx. 20 | Approx. 35 | Approx. 60 | Approx. 95 | Approx. 101 |
Voltage(V) | Approx. 0.7~0.8 | Approx. 1.3~1.4 | Approx. 2.3~2.4 | Approx. 3.7~3.8 | Approx. 3.9~4.1 |
Test Condition | GDS Parameter |
3. GDS Display for TPSTPS VOLTAGE |
Normal value with ignition "ON" & engine "OFF" | Accelerator pedal released | 0.20~0.47V |
Normal value with engine ON & accelerator pedal fully depressed | 4.2~4.7V |
Abnormal value with ignition "ON" & engine "OFF" | Power circuit open | 0.01V |
Ground cicuit open | 4.99V |
TPS signal circuit open | 4.99V |
TPS signal circuit short to ground | Approx. 0V |
TPS signal circuit short to battery | Above 4.99V |