Component Location
General Description
As inputted rail pressure sensor signal, ECM of Commom rail diesel engine controls fuel metering unit(MPROP-intergrated with high press. pump) and rail pressure control valve(PCV-integrated with common rail) in order to maintain optimum rail pressure according to current engine rpm and load.
However when the problem that leads rail pressure to out of target value intended by ECM occurs due to mechanical or electronical reason, ECM limits engine performance and sets DTC by limiting fuel (stops injector operation) in order to prevent engine from being controlled abnormally. "rail pressure monitoring error" is the DTC which diagnose 1).supplying state of low pressure fuel and 2).mechanical operating conditions of high pressure pump and 3). RPCV indirectly based on RPS output voltage and RPS duty. thus, repair relavant to this DTC requires mechanics the total understand of fuel system.
DTC Description
P1186 is set when rail press. is lower than target rail press. by 200bar in condition that rail press. is controlled by fuel metering unit(MPROP) and fuel flow quantity in High pressure pump reaches to the upper limit value. This code is due to 1)less than intended fuel supply to common rail or 2)excessive return of fuel supplied to common rail or 3)short to low voltage line in fuel press. sensor.
DTC Detecting Condition
Item | Detecting Condition | Possible Cause |
DTC Strategy | ? Voltage monitoring | ? Fuel pressure regulator valve(close stuck) ? Rail pressure control valve(open stuck) ? Rail pressure sensor(Output fixed at low voltage line) |
Enable Conditions | ? Engine running |
Threshold Value | ? (Case1) Actual rail press. is below the minimum posible rail press. at certain temp. at fuel pressure regulator valve(MPROP) operating condition. - 0.3 sec. ? (Case2) Actual rail press. is below the minimum posible rail press. at certain temp. at fuel pressure regulator valve(MPROP) operating condition and target high press. pump flow is below min value(-990?/s) - 2 sec. |
Diagnostic Time | ? Refer to Threshold value |
Fail Safe | Fuel Cut | NO | |
EGR Off | NO |
Fuel Limit | Case 1:YES Case 2:NO |
Check Lamp | Case 1:YES Case 3:NO |